MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Current mods for Willem dual power 4.5C board

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
nealg58 Posted - 12/10/2008 : 03:18:58
I have been reading the posts about the problems with the various boards concerning not enough programming current for the NMOS EPROMS. I am posting this to get feedback as to users thoughts about the mods I did to my 4.5C dual power board from Rebios.net by way of Sivava (LONG story).

I am using a 12vdc 2a external supply with the parallel cable that came with the programmer. I have .98D5, .98D2 and .97ja software installed just for grins. The board already has hefty transistors installed for the VPP & VCC1 switching, SS8550 - 40 volt @ 1.5 amp. I beefed up the 34063 supply - changed the rectifier from a 1N4001 to a 1N5819 (silicon to shockty diode), wound a beefer 100 uH coil with 24 ga wire on a toroid and changed the 0.5 ohm resistor to 0.39 ohm. I beefed up the 7805 regulator by adding a 18 ohm 1/2 watt resistor in series with the ground leg to raise the voltage .2 volts. A 1N4001 would raise the voltage .7 volts, which would be too much for some EPROMS. The resistor modification raised the VCC1 from 4.94 volts at pin 32 to 5.1 volts. I am still toying with changing the resistor on the base of the VPP transistor from 2.2k to 1.2k. This is the resistor that is taken to ground via the NPN transistor. I also added a 4069 (using 2 gates) to feed pins 2 & 12 (Q6 & Q7) of the 4014 (4021) to pins 12 & 13. This is to speed up data reading on larger E(E)PROMS. Some boards have this circuitry and some do not, the 4.5C does not.

Any thoughts/criticisms/comments welcome.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000