Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
chaos89-dot-com
Posted - 05/28/2006 : 22:30:44 I am having problems programming my STM27C800 eproms. I am getting the right voltage on pin 32(12.5V) I am using the same 16-bit adaptor as for my AM27C400 eproms. I have noticed it takes like hours to erase the STM27C800 eproms. Does it usually take hours to fully erase these STM27C800 eproms? Also, am I supposed to use the supplied address cable? I did try that too.
Thanks in advance!
1 L A T E S T R E P L I E S (Newest First)
ZLM
Posted - 06/04/2006 : 16:11:03 STM27C800 should use UV eraser to erase. Not the programmer.