MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Programming M27c1000 with GQ-4X

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
ifkz Posted - 07/25/2011 : 15:49:06
I just received this programmer today and I would like to start programming a bunch of ST M27C1000's. I selected the chip from the GUI and it gives me the message:
This chip needs a wire jumper from Address header A23 to ZIF Pin24.

I searched on Google and found A23 is pin 2 on the Ziff socket. I tried running a wire from pin 2 to pin 24 but then it could not verify a chip was blank.

Help!
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 07/30/2011 : 19:27:47
The original message is for GQ-3X.


For GQ-4X see:

4.13 KB

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.14 sec. Snitz Forums 2000