MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Atmel 89 adapter

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
daveg Posted - 12/11/2004 : 15:06:00
Hi,

Just received my unit and am trying to use the
Atmel 89 adapter to program a AT90S2313. I cannot
find that adapter in the list of devices for the
AT90S2313. Any help would be appreciated. Thanks.
3   L A T E S T    R E P L I E S    (Newest First)
daveg Posted - 12/16/2004 : 15:21:22
I think I found it. There is a "New Adapter" checkbox in
the AVR 8 bit RISC Lockbit/Fusebit Section that I turned on
and it appears that the AVR is now reading and writing.

Thanks.
daveg Posted - 12/16/2004 : 15:15:18
Thanks. I have put the Atmel 89 into the programmer,
but while in the program it does not give that adapter
as the one for the AT90S2313 IC. It shows a MCS-51 adapter
for this chip with 4 different IC sockets.
I have matched the Dip switch settings to the config that
appears for that adapter, but it does not seem to read and
write to the AT90S2313 AVR.
Any help would be appreciated.
usb Posted - 12/13/2004 : 12:37:02
This chip should be supported by this adaptor.
All you need is set the jumper to 90S position and put the chip in the 20pin ZIF.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.16 sec. Snitz Forums 2000