MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 27C256 jumper setting on dual power

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
ZLM Posted - 02/10/2006 : 22:29:26
6   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 09/06/2006 : 11:30:02
J3 is the #3 on your hardware board picture.
tizo Posted - 09/05/2006 : 12:24:49
thank you!

now i look better!

Just /maybe because my english is very bad :)/ i look two jumper on the picture /program/ 2 yellow and evry two in the left side :( wich is the j3?

thx

Why drink and drive, when you can smoke and fly :) ?
ZLM Posted - 09/05/2006 : 10:40:44
The Enhanced willem does not have the jumper 2 and 3 in the software. Instead it uses the LEDs to indicate the current jumper setting.

#3 in your borad picture(J3) is the A18/Vpp jumper. It located just left side of DIP in the software picture.
tizo Posted - 09/05/2006 : 01:24:03

Hi!

excuse but i m very newbie :) i m not realy sure.

please correct that:





thank you



Why drink and drive, when you can smoke and fly :) ?
ZLM Posted - 06/01/2006 : 16:06:54
All the jumper settings and DIP settings must be set same as above.
Your vertical jumper is for AT29C256. You have to remove it.
Batch Posted - 05/31/2006 : 17:33:09
ok the dip settings in the instructions were different than what you have showing. also, on the yellow jumper settings in the diagram, my board has one more jumper connecting the bottom 2 that are vertical of each other. Do I need to set them up like this? All the settings in your diagram is how the board should be correct? Thanks

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.15 sec. Snitz Forums 2000