MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 PCB3b just quit working...

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
ManiN Posted - 05/07/2011 : 10:35:12
Have what I think is a PCB3b that was working fine on epr097ja software. I burned a few chips, read a few etc. then the next time I pull it out it wont respond to the software. I noticed that when I plug the parallel cable in, the yellow vcc light no longer lights up like it did before. When I plug in the 12v supply, all the leds light up and the transistor next to the usb gets crazy hot. It got hot before in process of burning, but not just on standby. I think a component may have failed. Any others have this happen? I tried using different computer with a parallel to see if the vcc would come on, but nothing. Thanks for the insight!
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 05/11/2011 : 00:03:04
Your programmer may have some problem. You need to do a selftesting.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.24 sec. Snitz Forums 2000