T O P I C R E V I E W |
daveg |
Posted - 12/11/2004 : 15:06:00 Hi,
Just received my unit and am trying to use the Atmel 89 adapter to program a AT90S2313. I cannot find that adapter in the list of devices for the AT90S2313. Any help would be appreciated. Thanks. |
3 L A T E S T R E P L I E S (Newest First) |
daveg |
Posted - 12/16/2004 : 15:21:22 I think I found it. There is a "New Adapter" checkbox in the AVR 8 bit RISC Lockbit/Fusebit Section that I turned on and it appears that the AVR is now reading and writing.
Thanks.
|
daveg |
Posted - 12/16/2004 : 15:15:18 Thanks. I have put the Atmel 89 into the programmer, but while in the program it does not give that adapter as the one for the AT90S2313 IC. It shows a MCS-51 adapter for this chip with 4 different IC sockets. I have matched the Dip switch settings to the config that appears for that adapter, but it does not seem to read and write to the AT90S2313 AVR. Any help would be appreciated. |
usb |
Posted - 12/13/2004 : 12:37:02 This chip should be supported by this adaptor. All you need is set the jumper to 90S position and put the chip in the 20pin ZIF.
|