MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Vpp Range Error

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
onchip Posted - 12/17/2004 : 04:42:29
Hello

I bought on ebay an "Enhanced Universal Willem EPROM Programmer ZIF PLCC FWH" This is the exact model

Today I tried to get it working and with the first chip I used to reprogram (a Firmware Hub Intel 82802AB chip) I'm getting an error "Vpp Range Error". Does anyone have an idea to solve this problem? or to get more information regarding the use and troubleshooting with this Enhanced programmer?

I instaled the downloaded driver (parallel port IO driver), reboot, instaled the software (epr097g), turn of PC, connected cables (ECP+EPP bios configured), put Intel chip in the lower FW HLPC socket, turn on PC, started EpromM51 program, changed it to PCB3, configured it to Intel 82802AB, in help tested hardware and result was "hardware Present", tried to read the chip and result was OK, loaded a new bios code (xxx-bin) and tried to reprogram the chip with it and got "Vpp Range Error" !!!!!!!!!!!!!!!!!!!!!!!!!!!!

Any idea??

Thanks
3   L A T E S T    R E P L I E S    (Newest First)
usb Posted - 12/29/2004 : 18:47:38
Check the datasheet of N82802AB for Vpp. Use a multimeter to measure the ZIF pin 1 and pin 16 when you checked the Vpp in the software Test H/W page.
onchip Posted - 12/23/2004 : 08:34:59
I get the ID correct, more exactly - Manufacture: 0x89 Intel Device code: 82802AB -

I can read the chip content, no problem at all!

What is the correct value of Vpp to erase and program this Intel FWH N82802AB chip? And how can I mesure/verify it?

Thanks
usb Posted - 12/19/2004 : 23:17:40
Try to get ID before do anything else. If ID is correct then you need check the Vpp if it is presented correctly. If you are sure your setting is correct, then the programmer board may be defective on Vpp.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000