MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 GQ-4X 27C256 and 27256 VPP Voltage Value Settings

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
Krankshaft Posted - 06/29/2015 : 00:06:45
I have a question regarding the VPP voltage the GQ-4X applies to 27C256 CMOS EPROMS during programming.

While checking the details in the GQ-4X software I found that the programmer only applies 12 volts to VPP. While in an ST datasheet it says to apply 12.7 volts.

I then looked at the exact same size EPROM of the NMOS variety a 27256 and found the programmer applies 12.7 volts which falls into the tolerance specified on that parts datasheet (12.5V +- 0.3V).

Is there any particular reason less voltage is applied to VPP on the CMOS EPROMS compared to the NMOS or is that extra 3/4 of a volt just not that critical?

I've programmed both of these parts the code verified and they operate fine but I'm just curious.
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 07/03/2015 : 14:29:38
The standard programming voltage VPP can be 10% of standard. So, the 12V is working.


MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000