MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Open Source Project Willem Programmer Hardware
 Test my programmer - Is there a problem?
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

WhiteSI

5 Posts

Posted - 06/21/2005 :  08:02:52  Show Profile  Reply with Quote
I got some difficulty to program a AT29c256 with my new willem dual power programmer, and I wanted to know if the problem was my burner.

So I test my burner, here it's my result:

I just check one pin at a time, for example:





Set DIP switch as shown in the pictures...

1-VPP: 15,6V (VPP LED is ON)
2-A16: OV
3-A15: 2,4V
22-CE: 4,7V
26-A9: 3,7V (I think this is normal: A9 (pin 26) is lower because of the erase circuit,3..4 volt)
29-A14: 0V
30-A17: 0V
31-A18: 0V
32-VCC: 6,2V (VCC Led is ON)

any other pin is 5,4V

So I think there is some problem with my burner, don't you think?

Thanks
Reply #1

usb

138 Posts

Posted - 06/22/2005 :  11:51:14  Show Profile  Reply with Quote


Reffer to above picture.

I suspect one of the address chip(A1,A2,A3) been damaged since you could not detect the voltage on the address pin. Those three chips are same and can be swapped around between them. For the AT29C256 chip, only position A1, and position A2 been used. So, there will be a chance of working if only one of them been damaged.

The software need to close and re-start again after swapped the chip A1,A2,A3. So, please switch the chip arround between A1,A2 and A3.

If you still could not get the voltage, then you need return the programmer for the service or exchange.

Edited by - usb on 06/22/2005 11:53:55
Go to Top of Page
Reply #2

usb

138 Posts

Posted - 06/22/2005 :  13:10:28  Show Profile  Reply with Quote
Just noticed in your software setting you posted is in "Willem" mode.

The software MUST select the "PCB3" mod. See here:



Edited by - usb on 06/22/2005 13:11:56
Go to Top of Page
Reply #3

vincentes2000

France
6 Posts

Posted - 10/24/2005 :  04:38:50  Show Profile  Reply with Quote
For burn AT29C256 ... with Enhanced Willem ...

I must select PCB3 or Willem in the Software "Willem Eprom" ???

Go to Top of Page
Reply #4

usb

138 Posts

Posted - 10/25/2005 :  12:15:06  Show Profile  Reply with Quote
PCB3
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.2 sec. Snitz Forums 2000