MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Always buffer error PMC flash
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

plcc32chip

USA
9 Posts

Posted - 02/06/2009 :  01:09:14  Show Profile  Reply with Quote
i have an enhanced willem programmer, pcb5.0c.i have tried different PM49FL004T plcc32 chips and always return some buffer error.usually when verifying reaches 30%, sometimes at 80%. i tried on several pmc chips from working motherboards and still the same. i tried using external psu,set to 9volts and the same. the chip was correctly identified as pmc.

with other flash like sst(both lpc& fwh),winbond, i never have buffer error.

anyone having related problems on same or different chips and found a solution, please share. thank you.

Reply #1

ZLM

2937 Posts

Posted - 02/06/2009 :  08:52:34  Show Profile  Reply with Quote
Try to increase the R/C delay time, see if it helps.
Go to Top of Page
Reply #2

plcc32chip

USA
9 Posts

Posted - 02/06/2009 :  21:15:10  Show Profile  Reply with Quote
ok thank you. I will try this.
Go to Top of Page
Reply #3

MyLastWord

Canada
5 Posts

Posted - 09/30/2011 :  10:01:21  Show Profile  Reply with Quote
PLC32chip! Did increase the R/C delay time work?
ZLM! I have the same prolem to both PM49FL004T and SST46FL00B chips and increase R/C didn't work for me. It's alway error various address location. My board is PCB5.0e. Both identified correctly, both can be read, erase and program to all 0xFF or 0x00 correctly. It would program any other BIN file.

Any other things to check for? Thanks
Go to Top of Page
Reply #4

ZLM

2937 Posts

Posted - 10/06/2011 :  09:24:33  Show Profile  Reply with Quote
Try to adjust R/C delay time.
Go to Top of Page
Reply #5

MyLastWord

Canada
5 Posts

Posted - 10/11/2011 :  06:01:11  Show Profile  Reply with Quote
quote:
Originally posted by ZLM

Try to adjust R/C delay time.



ZLM. Thanks for reply. I did try to increase the R/C but without success. I did try incease to 100 & to the max also. Do you recommend a specific # or an increment #?
Adjust R/C delay time is too general given a wide range doesn't really help that much. Thanks
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000