MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Programming with GQ-4X
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

pinguy

USA
1 Posts

Posted - 02/14/2010 :  18:29:33  Show Profile  Reply with Quote
I just received my new programmer, and have burned a few chips. However, I often receive an error message "write failed at..."
Does this happen if the chip is not blank? Do I have to erase chips first?
I have successfully copied a program on to an ST M27C256, and then not been able to copy the same program to a different ST M27C256 chip.
Reply #1

ZLM

2937 Posts

Posted - 02/14/2010 :  21:21:56  Show Profile  Reply with Quote
The chip need to be erased before write any new data.

Do a blank check before write the data. This will tell you if the chip blank.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000