| Author |
 Topic  |
|
|
Kiwisek
Czech Republic
3 Posts |
 Posted - 08/18/2011 : 11:45:17
|
Hi all,
is it possible somehow force the GQ-4X to program MCM68764? It can program 2532 and the only difference is A12 on pin 21 of MCM68764. 25V programming voltage is also available, so I think this should be possible just by configuration change. But how to change the configuration?
Ragards, Martin. |
|
| Reply #1
ZLM
2947 Posts |
Posted - 08/19/2011 : 16:39:34
|
| You may need to make a adapter for your chip. |
 |
|
| Reply #2
Kiwisek
Czech Republic
3 Posts |
Posted - 08/23/2011 : 15:35:29
|
quote:
Originally posted by ZLM
You may need to make a adapter for your chip.
Thanks, I could do that, but what chip would you suggest I should set in porgrammer and make the adapter for?
Regards, Martin. |
|
|
| Reply #3
ZLM
2947 Posts |
Posted - 08/25/2011 : 10:41:01
|
2732,2764.
as long as you use same capacity, same programming voltage EPROMs. You may need to see the datasheet to find a similar chips. |
|
|
| Reply #4
Kiwisek
Czech Republic
3 Posts |
Posted - 09/13/2011 : 11:23:21
|
| Maybe with some adaptor. These chips have diferent pinout (a little bit). |
|
|
| Reply #5
mr_hollywood
2 Posts |
Posted - 11/22/2025 : 21:34:28
|
Fyi, submitted a GQ4x4 "Chip support request" for the MCM68764 last week, and the response indicated there were 9 previous requests for this chip.
Anyone know how often the GQ4x4 software typically gets updated?
|
|
|
| |
Topic |
|
MCM68764
