MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 EasyPRO/SmartPRO USB Programmer
 Can't program CAT28C64's		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

sJv

USA
2 Posts
Posted - 01/11/2007 :  12:13:00  Show Profile  Reply with Quote
For some reason, my 90B gets an error when trying to program this Catalyst EEPROM. It's able to program 4 or 5 bytes before it errors out. I have tried two CAT28C64's with the same result. Oddly enough, I see in the TOP forum that someone had a similar issue with this same part on their TOP2004 programmer. Anyone have any ideas?

ZLM: do you have any connection with the factory to submit bug reports?

-steve
Reply #1

ZLM

2937 Posts
Posted - 01/12/2007 :  12:23:43  Show Profile  Reply with Quote
I do not have any contact with the factory. However, you may use following link to report thr bug:

http://www.programtec.com/english/news/contact%20us.asp

or

http://www.programtec.com/english/news/support.asp
Edited by - ZLM on 01/12/2007 12:24:00
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000