MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Open Source Project Willem Programmer Hardware
 PIC Adapter+ Questions
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

w4rfj

USA
1 Posts

Posted - 08/25/2007 :  06:04:26  Show Profile  Reply with Quote

Is there a schematic available for the PIC Adapter+?

I also noticed that the name of the pins on the adapter do not match the name of the pins on your Dual Power programmer...

Will the PIC Adapter+ plug directly unto the Dual Power Willem Programmer? and... Could you supply documentation concerning the use of the PIC Adapter+?

Reply #1

ZLM

2936 Posts

Posted - 08/25/2007 :  14:47:10  Show Profile  Reply with Quote
The adapter will directly plug in to the all Willem programmers. Include Dual Power Willem.

The adapter has 5 pin ICSP port wich is same as programmer's pin out.
Go to Top of Page
Reply #2

BlueSky

14 Posts

Posted - 08/25/2007 :  16:08:50  Show Profile  Reply with Quote
The pin out on adapter board should be: Vpp Vcc Gnd RB7 RB6
You can ignor the pin out print on the adapter and just plug it on the programmer's ICSP header.

Also, set the jumper correctly for 8-18 pin or 28-40pin selection on the adapter.

Edited by - BlueSky on 08/25/2007 16:09:16
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000