MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 Support for Macronix 25U4035
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

vertigosystems

USA
4 Posts

Posted - 06/12/2019 :  11:23:55  Show Profile  Reply with Quote
Is there any way I can wrangle support for the 25U4035 into the app? It's a 4mbit, 1.8V serial eeprom, but I can't find a pinout for it.

Macronix brochure was the only mention of it I could find and it was light on the details. These are common eeproms on Toshiba and Samsung HDD interface PCBs and rather than risking damage with heating the board to remove the chip, I'd like to do a reprogram with a clip to transfer firmware from one board to another.

Vertigo Systems LLC - Technically, the Best!
Reply #1

anniel

2531 Posts

Posted - 06/12/2019 :  14:59:30  Show Profile  Reply with Quote
quote:
Originally posted by vertigosystems

Is there any way I can wrangle support for the 25U4035 into the app? It's a 4mbit, 1.8V serial eeprom, but I can't find a pinout for it.

Macronix brochure was the only mention of it I could find and it was light on the details. These are common eeproms on Toshiba and Samsung HDD interface PCBs and rather than risking damage with heating the board to remove the chip, I'd like to do a reprogram with a clip to transfer firmware from one board to another.


The datasheet is quite explicit.

1-CS#
2-SO/SIO1
3-WP#/SIO2
4-GND
5-SI/SIO0
6-SCLK
7-RESET#/HOLD#/SIO3
8-VCC
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000