MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 How to Set up 16Bit Adapter?
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

vk4akp

Australia
28 Posts

Posted - 02/15/2008 :  09:39:31  Show Profile  Reply with Quote
Hi, I'm trying to use the 16 Bit Eprom adapter (V2.0) for the first time.

Programmer is GQ-3X RE-1.00 USB, Software is 2.05Beta.

It comes with 3x coloured jumper cables (Orange, Purple, Red).

There is no information where these cables go? I assume they power the 16Bit daughter board?

The Chip we are working with currently is MX27c4100DC-12.

The software says to use the daughter board, but gives no more information as to where the cables go or which socket to use. :(

Any help appreciated.

~Ken
.-.-.
Reply #1

ZLM

2937 Posts

Posted - 02/16/2008 :  23:01:21  Show Profile  Reply with Quote
The MX27c4100DC is 27C400 compatible. So, it should go 42 pin socket and bottom aligned with the socket.

No address wire is required on this chip.
Go to Top of Page
Reply #2

vk4akp

Australia
28 Posts

Posted - 02/25/2008 :  14:45:33  Show Profile  Reply with Quote
OK, thanks.

Yea I got it working.

The chips were blank , but not UV blank at the time which was what confused me.

The seller must have tested them by blanking them and then writing Blank fill back to the chip. (Bit strange).

.-.-.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000