MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Programming SST39VF080 on laptop motherboard
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

chopper3200

1 Posts

Posted - 01/18/2010 :  16:00:23  Show Profile  Reply with Quote
Hi, I'm wanting to program a 40 pin SST39VF080 chip that is on a laptop motherboard, there is a solder pad header on the board and I have the GQ-4X programmer which supports this chip, but the software says I need a TSOP40 to DIP32 adapter if the chip was taken off the board to be programmed. Can I connect pin 1 to 1 through 40 to 40 between the chip and the programmer? Do I need to make a special Device line to program it this way without the adapter? If so what would it be? Thanks!
Reply #1

ZLM

2937 Posts

Posted - 01/18/2010 :  23:51:41  Show Profile  Reply with Quote
The chip can not be programmed on board. You have to place it in a adaper and then program it on the programmer.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000