MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Setting "Start of Device Value"		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

KAZ MotorSports

2 Posts
Posted - 10/03/2006 :  17:34:14  Show Profile  Reply with Quote
Hello folks,

I am a car tuner here in Colorado Springs.

I am currently dropping in a SST27SF512 in the place of a 27C256 chip. The site I bought the chip from says that to use the 27SF512 in place of a 27C256 that I must adjust the 'Start of Device' value when programming for 27C256 original, set to 8000 hex.

How do I do this on a Dual Power Willem Universal EPROM Programmer with the latest software version?

I did see how to adjust the jumper blocks for the proper read/write and then to erase, but curious how to change the start of device if possible.

Thanks much in advance!
-Kenny
KAZ MotorSports
Reply #1

BlueSky

14 Posts
Posted - 10/03/2006 :  20:53:13  Show Profile  Reply with Quote
Start Offset:

58.03 KB
Go to Top of Page
Reply #2

KAZ MotorSports

2 Posts
Posted - 10/04/2006 :  06:55:50  Show Profile  Reply with Quote
BlueSky...if you are ever in Colorado Springs I owe you a beer/soda/water whatever your poison!

Thank you VERY much!
-Kenny
Go to Top of Page
Reply #3

84sslt1

USA
13 Posts
Posted - 05/01/2008 :  06:28:24  Show Profile  Reply with Quote
Hey fellas!! How do I tell what device I had originally? 93 lt1 z28 Thanks
Tim
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000