MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Atmel 89 adapter
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

daveg

3 Posts

Posted - 12/11/2004 :  15:06:00  Show Profile  Reply with Quote
Hi,

Just received my unit and am trying to use the
Atmel 89 adapter to program a AT90S2313. I cannot
find that adapter in the list of devices for the
AT90S2313. Any help would be appreciated. Thanks.
Reply #1

usb

138 Posts

Posted - 12/13/2004 :  12:37:02  Show Profile  Reply with Quote
This chip should be supported by this adaptor.
All you need is set the jumper to 90S position and put the chip in the 20pin ZIF.
Go to Top of Page
Reply #2

daveg

3 Posts

Posted - 12/16/2004 :  15:15:18  Show Profile  Reply with Quote
Thanks. I have put the Atmel 89 into the programmer,
but while in the program it does not give that adapter
as the one for the AT90S2313 IC. It shows a MCS-51 adapter
for this chip with 4 different IC sockets.
I have matched the Dip switch settings to the config that
appears for that adapter, but it does not seem to read and
write to the AT90S2313 AVR.
Any help would be appreciated.
Go to Top of Page
Reply #3

daveg

3 Posts

Posted - 12/16/2004 :  15:21:22  Show Profile  Reply with Quote
I think I found it. There is a "New Adapter" checkbox in
the AVR 8 bit RISC Lockbit/Fusebit Section that I turned on
and it appears that the AVR is now reading and writing.

Thanks.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000