MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Help with EFI (bios) chip Mac
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

machack

USA
2 Posts

Posted - 01/09/2013 :  19:02:54  Show Profile  Reply with Quote
Great site!
I would like to get help with trying to program the EFI chip on a MacBook Pros logic board. I am tying to erase and then program a non corrupt bios .bin file to the chip while its soldered to the board. The problem is the Mac will not boot so my hope is to correct the issue with a clean install of the efi or bios. I have a GQ-4x and the chip that apple uses is a MX25L3205D. I have been able to read the chip on a couple boards but I cannot erase or write to them. The programmer gives me a error when I try to id the chip. I pulled the data pdf from online and it looks like I should connect 1-CS 2-SO/sio 4-grnd 6-clk 5-si.
But no matter how i connect things I still get errors. Do I need an external power supply to power the chip? Any help would be great.
Reply #1

ZLM

2937 Posts

Posted - 02/28/2013 :  00:23:32  Show Profile  Reply with Quote
You do not need an external power. The USB power is good enough.

Are you using adapter or just a DIP chip?

Check followings:

1. adapter must be pin-pin converstion
2. all pins have no contacting problem.
3. chip orientation
4. make sure the chip is a good chip.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000