MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 ST 27C256B 15C1 PLCC-32
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

rgarito

2 Posts

Posted - 03/25/2017 :  08:55:52  Show Profile  Reply with Quote
Hello. I am having difficulties reading this chip using the GQ-4x v4 Programmer with the ADP-062 adapter and 7.11 firmware/3.0 driver. I have tried all speeds and even the ID reads give different results every time (and none of the ID read attempts match 208d as the data sheet specifies).

This is a known-good EPROM out of a working device.

I have successfully used this reader to read other EPROMS in the past (but not of this type) without any issues.

Thoughts?

Edited by - rgarito on 03/25/2017 10:09:14
Reply #1

anniel

2531 Posts

Posted - 03/25/2017 :  10:36:25  Show Profile  Reply with Quote
Check your pin for good contact between chip-adapter-programmer.

You should be able to get a chip ID before doing something else.
Go to Top of Page
Reply #2

rgarito

2 Posts

Posted - 03/25/2017 :  10:42:17  Show Profile  Reply with Quote
quote:
Originally posted by anniel

Check your pin for good contact between chip-adapter-programmer.

You should be able to get a chip ID before doing something else.



Yep, I already verified that. The adapter is brand new, too (the programmer itself is about a year old, and works fine with other devices). I see another post further down where someone else is having problems with the Chip ID on the v4 box (different chip) and there was a post that there could be a new bug in the firmware/software?
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000