MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 reading AM29F800 w/ dual power willem
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

busta9876

USA
6 Posts

Posted - 06/15/2011 :  16:41:22  Show Profile  Reply with Quote
I'm having some issues getting a good READ from a AM29F800 chip.

I will read it, then turn around and verify buffer, and I come up with BYTES that are just a little different.

example: Chip = 0xFE Buffer = 0xFF or chip, 0xAA, buffer= 0xAB

over the whole file, about 10 of these. I can correct the hex value in the buffer, then verify again, and it goes a little further. So far I'm up to $0B3730 of the chip and have had 6 corrections. each time I make a correction to buffer, it has ALWAYS gone farther before throwing the next difference at me.

any ideas? I've changed the timing a little, i'm at 4 uS on tWP and 32 uS on tWC
Reply #1

ZLM

2926 Posts

Posted - 06/29/2011 :  18:32:52  Show Profile  Reply with Quote
check you pin contact.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.27 sec. Snitz Forums 2000