MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Programming M27c1000 with GQ-4X
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ifkz

1 Posts

Posted - 07/25/2011 :  15:49:06  Show Profile  Reply with Quote
I just received this programmer today and I would like to start programming a bunch of ST M27C1000's. I selected the chip from the GUI and it gives me the message:
This chip needs a wire jumper from Address header A23 to ZIF Pin24.

I searched on Google and found A23 is pin 2 on the Ziff socket. I tried running a wire from pin 2 to pin 24 but then it could not verify a chip was blank.

Help!
Reply #1

ZLM

2937 Posts

Posted - 07/30/2011 :  19:27:47  Show Profile  Reply with Quote
The original message is for GQ-3X.


For GQ-4X see:

4.13 KB
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000