| Author |
 Topic  |
|
|
nik7dob@gmail.com
Bulgaria
8 Posts |
 Posted - 03/16/2015 : 16:22:36
|
Well... so I read that flash and copied it to another chip. I put the ECU back and the car wont start, ant there is no comunication trough CAN - the ECU is dead. After 3 hours soldering and desoldering thetwo flash chips on the two same ECUs I found that GQ-4X read the first 50% of the file and after that read it again ne more time, so at the end of reading I have file 1024 kb and inside are 2 exactly same codes 2 x 512 kb.
When I wtite to the chip if the file is 2 x 512 same code , write and verify it good. But when I changed the first 50% of the file ot second, then the programer write it double and the vertification failed at the adress I changed the code. Please help me, the customer is waiting for the car. That wasnt the proper moment for failing with that programer...
I read/write AM 28F400 BB with no problem |
Edited by - nik7dob@gmail.com on 03/16/2015 16:23:31
|
|
| Reply #1
nik7dob@gmail.com
Bulgaria
8 Posts |
Posted - 03/17/2015 : 08:40:00
|
| Somebody with information about that issue? |
 |
|
| Reply #2
nik7dob@gmail.com
Bulgaria
8 Posts |
Posted - 03/18/2015 : 00:51:35
|
ZLM, any ideas? Its urgent... The programmer can work with 29F800, but now dont work good, why I bought this programmer?
|
|
|
| Reply #3
ZLM
2947 Posts |
Posted - 03/18/2015 : 13:56:21
|
It seems the A19 lost connection.
If you are not using ADP-019 from MCUmall, then you need to make sure the A19 is connected between programmer and the adapter.
The ADP-019 V2 or V4 has buit in A19 connection on GQ-4X. But all other paralle Willem programmer adapter have no 19 connection, you need to connect it manually on GQ-4X.
See:
|
|
|
| |
Topic |
|
Problem reading/writing AM29F800 BB
