MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using the AVR JTAG ICE and AVRISP ISP programmer
 Atmega 328P-PU How can clone this
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

danmarq

11 Posts

Posted - 12/17/2017 :  15:27:20  Show Profile
Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so...

How can i do this is possible ?

the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?

Someone can do this before ?

Regards :)
Reply #1

danmarq

11 Posts

Posted - 12/17/2017 :  22:33:33  Show Profile
Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :)
Go to Top of Page
Reply #2

anniel

2564 Posts

Posted - 12/18/2017 :  04:20:11  Show Profile
quote:
Originally posted by danmarq

Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so...

How can i do this is possible ?

the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?

Someone can do this before ?

Regards :)



SCK is pin 19.

Go to Top of Page
Reply #3

anniel

2564 Posts

Posted - 12/18/2017 :  04:21:36  Show Profile
quote:
Originally posted by danmarq

Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :)



+1 Good info for others in same situation.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000