MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 General Discuss
 Programming M27C4001?
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Megadiver

3 Posts

Posted - 12/12/2004 :  10:12:43  Show Profile  Reply with Quote
I have an enhanced Willem Programmer and am having a problem programming this chip. I get this message:

Error at 0x000000 Chip=0x20 Buffer=0xE2

Any ideas? This programmer is supposed to program this chip with no problem. No special(top) jumpers have been changed. It reads the chip and verifies empty but thats all I can do.
Thanks
Reply #1

mcumall

78 Posts

Posted - 12/13/2004 :  13:02:18  Show Profile  Reply with Quote
If you can confirm the chip can be read correctly, then you need check the Vpp if any problem (you need use the Test H/W page).

You also can write the chip more than onece. If the byte can be write in this case, most likely the problem is the Vpp or Vcc issue. That means this chip is sensitive to Vpp/Vcc when programming. You may need adjust the Vpp/Vcc value a bit.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000