MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Automobile engine ECU, Immo, Air bag chip tunning
 Use a 27c64 to carry dual 27c32 eprom
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

magloman

Sweden
16 Posts

Posted - 06/28/2009 :  14:36:19  Show Profile
Hi folks,

Tried today by making a adapter cable for using dual 4k eprom into one 8k.

The eprom is supposed to be used in a Volvo 760 Turbo 1984-85 in Motronic 012 ECU. Then a switch to choose lower or upper data in the 8k eprom.

Found some info in a forum long time ago that I had saved.

The pinouts is not the same so I took a solder DIL24 socket and attach cables on top of it, then led thoose to an experiment circuit board where I have a ZIF28 socket.

I connected the first 12 adress(a0-a11) cables and all 8 data cables.
Then
ZIF28-20 to DIL24-18 (what is this?)
ZIF28-28 to DIL24-24 (Vcc)
ZIF28-1 to DIL24-20 (Vpp) Is this necessary if you only read ?
ZIF28-14 to DIL24-12 (gnd)
ZIF28-27 to ZIF28-14 (gnd) Why ??
ZIF28-2 to switch alternating to ZIF28-14(gnd) or ZIF28-28 (Vcc)

Then I programmed a 27c64 with 4k, then again with offset 1000.
Verifies and ok. If I remove the ofset and read from the eprom the buffer fills up as it should with different data.

Then I connect my adapter to my GQ-3X and choose 27c32b(I think) and tries to read it. No matter how my switch is, there is only FFs read.

It seems my adapter does not work. What could be wrong ?
I belive my adapter cable is about half feet long. The cable is a floppy drive cable(flat ribbon type, gray)

Is it to small area in the cables ??

Any ideas, someone ??
Reply #1

ZLM

2945 Posts

Posted - 06/28/2009 :  18:15:55  Show Profile
check pinout for your connection:

http://www.mcumall.com/forum/topic.asp?TOPIC_ID=29
Go to Top of Page
Reply #2

magloman

Sweden
16 Posts

Posted - 06/28/2009 :  23:06:15  Show Profile
well, thanks for the link

I have gone through my pinout again, and the only thing that does not add upp to me is that I have grounded the ZIF28-27. Will remove that and see.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000